Car steering Toyota RAV4 1 (XA10)

General information about steering
The steering system consists of a steering wheel, a steering column, a steering gear and tie rods. The steering wheel, mounted on the steering column, transmits force to the rack and pinion transmission. The steering...

Steering specifications
Technical characteristics of steering units are given in the table. 13.1. The front wheel alignment angles and tightening torques of the main connections are given in the table. 13.2.

Removal and installation a steering wheel with an airbag
Attention! Vehicles are equipped with safety systems (SRS), including airbags and seat belt tensioners. Before working near the impact sensors, instrument panel, and steering column, disconnect the negative and then...

Removal and installation the steering column
Remove the steering column as follows: Turn off the ignition, disconnect the ground wire from the battery and wait 2 minutes before performing further work. Set the wheels to move straight ahead. Remove the steering...

Removal and installation tie rod ends
Remove the tie rod ends as follows. Apply the parking brake and block the rear wheels with chocks. Loosen the front wheel mounting nuts. Raise the front of the vehicle and support it on stands. Remove the front wheel....

Replacing the steering gear covers
Replace the steering gear covers as follows: Apply the parking brake and block the rear wheels with chocks. Loosen the front wheel mounting nuts. Raise the front of the vehicle and support it on stands. Remove the front...

Removal and installation the steering gear
Attention! Vehicles are equipped with safety systems (SRS), including airbags and seat belt tensioners. Before working near the impact sensors, instrument panel, and steering column, disconnect the negative and then...

Removal and installation the power steering pump
To remove the power steering pump for models prior to 2001, proceed as follows. Turn off the ignition and disconnect the ground wire from the battery. Use a syringe to suck the fluid out of the power steering reservoir....

Bleeding the hydraulic power steering system
Air gets into the hydraulic system when the system is depressurized during repairs, replacement of individual components or fluid. When bleeding the hydraulic power steering system, proceed as follows: Set the front...

Replacing wheel mounting bolts
The operations for replacing the front and rear wheel mounting bolts are performed in the same way. When replacing wheel bolts, proceed as follows: Loosen the wheel nuts. Raise the vehicle and place it on supports....

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Steering Toyota Carina T170 (1988-1992)
➥ Steering Toyota Camry XV20 (1996-2001)
➥ Steering Toyota Corolla E80 (1983-1990)
➥ Steering Toyota Dyna Y50/Y60 (1984-1995)
➥ Steering Toyota Cruiser 100 (1998-2007)
➥ Steering Toyota 4Runner N120 (1989-1995)

Link in different formats to this article

TEXTHTMLBB Code

RAV 4 XA20 (2000-2005)