OBD-II Trouble Codes [Toyota RAV4 XA10]

If the CHECK ENDINE indicator lamp comes on, it indicates that a malfunction has occurred during the last two trips.

Figure 7.3. Location of the 16-pin Data Link Connector (DLC)

OBD-II diagnostic codes can be retrieved from the PCM by connecting to the electrical data link connector located on the left side under the instrument panel (figure 7.3). Diagnostic trouble codes are shown in the table. 7.5.

(The article was copied from the portal: «ToyotaMan»)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kolokoltsev Grigory

Share information:

◀ Previous

RAV 4 XA10: Toxicity reduction system

Next ▶

Executive devices
Information sensors
On-board diagnostics (OBD) system
Technical characteristics of the toxicity reduction system
General information about the exhaust emission control system

Engine control unit (PCM)
Replacing the throttle position sensor (TPS)
Replacement of the intake manifold absolute air pressure sensor on models…
Replacing the Mass Air Flow (MAF) sensor on 2001 and later models
Replacing the engine air temperature (IAT) sensor on pre-2001 models

Similar articles on other Toyota models

➥ Engine Management System Diagnostic Trouble Codes Toyota Camry XV30 (2001-2006)
➥ Engine Management System Diagnostic Trouble Codes Toyota Duet (1998-2004)
➥ Fuel injection system fault codes Toyota Corolla E80 (1983-1990)
➥ Diagnostic codes for the electronic control unit Toyota Corona T190 (1992-1997)
➥ Diagnostic codes for the electronic control unit (2C) Toyota Carina T190 (1992-1996)
➥ On-Board Diagnostics (OBD) System — Operating Principle and… Toyota Cruiser 100 (1998-2007)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

RAV 4 XA20 (2000-2005)