Car transfer case Toyota 4Runner 2 (N120)

Transfer case — design description
Transfer case 1. Handle; 2. Top panel; 3. Floor section box; 4. Transfer case control lever; 5. Retaining ring; 6. Speed sensor connector; 7. Rear propeller shaft; 8. Transfer case locking switch connector; 9. Transfer...

Transfer case technical data
Actuator resistance – between terminals 2 and 3 0.3 – 100 Ohm – between terminals 2, 3 and ground not less than 0.5 Mohm Tightening torques (Nm) Cardan shaft flange nuts 106 PTO shaft cardan joint nut 134 Gearbox Lever...

Front and rear flange seals — replacement
1. Raise the car. 2. Remove the driveshaft (front or back). 3. Uncounter (bend back the flange) (photo on the left) and unscrew the flange nut (photo on the right). 4. Remove the flange, use a puller if necessary. 5....

Transfer case lever — removal and installation
1. On vehicles without a front axle selector, move the gearshift lever to position 4 High. On vehicles equipped with a selector, move the gearshift lever to position High and set the front axle selector (2WD-4WD) to...

Electromagnetic switch (selector) of the front axle
Front Axle Electromagnetic Switch 1. Actuator; 2. Front axle position switch; 3. Demultiplier position switch; 4. ECU unit 5. Control lamp; 6. Front axle switch on the transfer case lever handle; 7. Locking switch; 8....

Switch on the transfer case lever handle
Check and replace 1. Remove the handle. 2. Check the switch. There should be no circuit between terminals 1 and 2 in the Off position, but there should be a circuit between these terminals in the On position. 3. If the...

Actuator — Checking and replacing
1. Raise the car. 2. Disconnect the connector from the actuator. 3. Check the resistance between terminals 2 and 3 of the connector. 4. Check the resistance between terminals 2, 3 and ground. 5. If the resistance...

Speed sensor — checking and replacement
Speed sensor testing circuit 1. Connect the (+) battery to terminal 1 of the sensor, and the (-) battery to terminal 2. Connect the (+) voltmeter terminal to terminal 3, and the (-) voltmeter terminal to terminal 2,...

Front axle selector indicator light
If the indicator lamp does not light, check the fuse. If the fuse is intact, disconnect the connector from the transfer case position switch and connect it to ground. If the lamp lights, the position switch is faulty....

Removal and installation the transfer case
Removal 1. Remove the gearbox lever. 2. Disconnect the breather hose. 3. Raise the car. 4. Remove the shield (the arrows show the shield bolts). 5. Drain the oil from the transfer case. 6. Remove the drive shafts. 7....

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Transfer case Toyota Cruiser 60/80 (1980-1997, petrol)

Link in different formats to this article

TEXTHTMLBB Code