Electric power devices Toyota 4Runner 2 (N120)

Battery — Removal and Installation
1. Disconnect the battery cables (disconnect the negative terminal first, then the positive terminal). 2. Disconnect the mounting clamp. 3. Remove the battery, inspect the tray, check for corrosion. 4. When replacing...

Battery Charging System — Design Description
Battery charging system 1. Ignition key; 2. 10 A fuse link; 3. Charge indicator lamp; 4. Stator winding; 5. Rotor winding; 6. Generator; 7. Voltage regulator; 8. Battery; 9. Main fuse link Typical arrangement of fuse...

Checking the battery charging system
Circuit for checking battery charging current 1. Generator; 2. Voltmeter; 3. Battery; 4. Disconnect the wire; from output B; 5. Ammeter 1. If the battery charging circuit is faulty, perform the following checks before...

Generator — removal and installation
Mounting the generator on 4-cylinder engines 1. Lock bolt; 2. Axle bolt; 3. Belt; 4. Generator Mounting the generator on a V6 engine 1. Adjusting bolt; 2. Generator; 3. Lock nut; 4. Belt; 5. Axle bolt Removal and...

Generator Parts — Checking and Replacing
Generator parts (typical variant) 1, 16. Bearing cover; 2, 15. Bearing; 3. Rotor; 4. Back cover; 5. Brush holder; 6. Insulating bushing; 7. Rear bearing housing; 8. Rectifier contact plate; 9. Voltage regulator; 10....

Engine starting system — design description
Starter and traction relay parts 1. O-ring gasket; 2. Front lid; 3. Roller; 4. Limiter; 5. Overrunning clutch assembly; 6. Spring; 7. Traction relay assembly; 8. Ball; 9. Intermediate gear; 10. Gear; 11. Tie bolt; 12....

Checking the starter motor without removing it from the vehicle
Starting circuit mounting locations 1. Starter; 2. Insert FL-ALT (80A); 3. Park/Neutral switch; 4. Insert FL-AM1 (40 A); 5. Traction relay switch; 6. Auxiliary relay 1. If the starter motor does not turn at all when you...

Removal and installation the starter motor
Starter bolts and wires (4-cylinder engine) 1. Starter; 2. Connector; 3. Power cable 1. Disconnect the battery from ground. 2. Raise the front of the car. 3. Disconnect the wires from the starter. 4. Loosen the starter...

Starter Solenoid Relay — Removal and Installation
1. Remove the starter. 2. Mark the position of the traction relay on the starter. 3. Disconnect the starter power bus. 4. Unscrew the screws (indicated by arrows) fastenings of the starter gearbox. 5. Loosen the tie...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Power devices Toyota Camry XV30 (2001-2006)
➥ Power devices Toyota RAV 4 XA10 (1994-2000)
➥ Starting and charging system Toyota Dyna Y50/Y60 (1984-1995)
➥ Power devices Toyota Corolla Verso 3 (2004-2009)
➥ Charge and start system Toyota Cruiser 70 (1985-1996, diesel)
➥ Power devices Toyota Carina T170 (1988-1992)

Link in different formats to this article

TEXTHTMLBB Code