Doors, locks and windows of the car Toyota 4Runner 2 (N120)

Hinges and locks — care
Every 5,000 km, or every three months, apply a few drops of light oil or lock lubricant to the hinges and latches on the doors, bonnet and boot. Door lock latches also need to be coated with a thin layer of grease to...

Windscreen and fixed glass
Replacing the windshield and fixed glass requires the use of a special fast-curing adhesive or sealant and some specialized equipment. It is recommended that these operations be performed at service stations.

Door trim panel — removal and installation
1. On vehicles equipped with power windows, disconnect the battery from ground. 2. Remove the window lift handle (on a car without electric drive). To do this, place the cord under the handle and remove the locking ring...

Door — removal and installation
1. Disconnect the battery from ground. 2. Remove the door trim. 3. Label and disconnect all connectors, remove wire harnesses from the door. 4. Open the door fully and support it with a block or stand. 5. Draw the...

Cargo Compartment Door — Removal, Installation and Adjustment
Attention! Work is performed by two people. 1. Disconnect the battery from ground. 2. Open the compartment door and secure it securely. 3. To remove the cargo door pillars, unscrew the upper (photo on the left) and the...

Cargo door glass and window lifter
Cargo compartment door 1. Window lifter; 2. Right guide; 3. Glass; 4. Lid; 5. Edging; 6. External seal; 7. Casing; 8. Inner seal; 9. Door trim; 10. Decorative overlay; 11. Lock switch drum; 12. Ejector; 13. Castle; 14....

Door glass — removal and installation
1. Roll down the window. 2. Disconnect the battery from ground (if an electric drive is provided). 3. Remove the outside mirror. 4. Remove the door trim and water shield.

Front door window lifter — removal and installation
Front door 1, 14. Seal; 2. Mirror; 3. Overlay; 4, 18. Guides; 5. Loop; 6. Door stop; 7. Without electric window lift; 8, 19. Window lifter; 9. Washer; 10. Handle; 11. Retaining ring; 12. Inner handle; 13. Screen; 15....

Rear door window lifter — removal and installation
Back door 1. Corner with seal; 2. Glass; 3, 20. Seal; 4. Edging; 5. Dividing bar; 6. Lock button; 7. Loop; 8. Limiter; 9. Window lifter; 10. Screen; 11. Without electric window lift; 12. Window lifter; 13. Retaining...

Electric window lift — removal and installation
1. On vehicles equipped with power windows, disconnect the battery from ground. 2. Remove the door trim and screen. 3. Remove the glass. 4. Remove the lock retainer and the outside door handle. 5. Disconnect the...

Lock catch, lock switch and door handles
Removal and installation 1. On vehicles equipped with power windows, disconnect the battery from ground. 2. Remove the door trim and screen. Fixator 3. Remember the order of connecting the rods with the latch by...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Doors, windows and locks Toyota Corona T190 (1992-1997)
➥ Doors, locks and windows Toyota Highlander 1 (2000-2007, petrol)
➥ Doors, locks and windows Toyota Camry XV10 (1991-1996)
➥ Doors, locks and windows Toyota Cruiser 100 (1998-2007)
➥ Doors, locks and windows Toyota RAV 4 XA10 (1994-2000)

Link in different formats to this article

TEXTHTMLBB Code