If the indicator lamp does not light, check the fuse. If the fuse is intact, disconnect the connector from the transfer case position switch and connect it to ground. If the lamp lights, the position switch is faulty. If the lamp does not light, check the lamp and wires.
[The original can be viewed on the website: ToyotaMAN]
Front axle selector indicator light [Toyota 4Runner N120]
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
The article material has been checked: Gribkov Vladimir
Share information:
Similar articles on other Toyota models
➥ Checking the indicator lights (except the low fuel light) Toyota Camry XV30 (2001-2006)
➥ Front Axle Hub — Design Description Toyota Corona T190 (1992-1997)
➥ Front axle hub device Toyota Carina T190 (1992-1996)
➥ Rear (front) axle — removal and installation Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Direction indicator and hazard warning light relay —… Toyota Highlander 1 (2000-2007, petrol)
➥ Replacing the front seal of the rear axle gearbox Toyota Duet (1998-2004)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- 4-cylinder engines
- 6-cylinder engines
- Engine overhaul
- Cooling and heating
- Fuel system
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Transfer case
- Clutch
- Transmission line
- Chassis, running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Ignition system
- Power devices
- Electrical circuits