Turn off the ignition and disconnect the wire «masses» from the battery.
On manual window models, fully close the window and mark the position of the window handle.
Release the mounting bracket and remove the handle.
The bracket is released by inserting a clean cloth between the handle and the door upholstery and, pulling the cloth against the ends of the bracket, hook the bracket and release it.
Pic. 14.20. Removing the power window handle using a clean cloth
In this case, it is necessary to pull the handle towards you so that after releasing the bracket it is removed from the slots of the power window (pic. 14.20).
Pic. 14.21. Removing the panel with power window switches
On power window models, use a screwdriver blade to separate the power window switch panel to access one of the door trim screws (pic. 14.21). Disconnect electrical connectors from panel.
Pic. 14.22. Removing the inner decorative cover of the outside rear-view mirror
Remove the inner decorative cover of the outside rear-view mirror by pulling it out (pic. 14.22).
Pic. 14.23. Removing the door handle trim on models from 2001
On models since 2001, use a screwdriver blade to remove the door handle trim (pic. 14.23).
Pic. 14.24. Location of door trim screws on models from 2001 (on models up to 2001 there are two more screws in the door pocket area)
Loosen the door trim screws (pic. 14.24). Using a screwdriver with a wide blade, separate the door trim from the door around the perimeter. The rear upholstery is fastened with clamps and three screws. Two screws are located under the cover of the door opening handle and one screw is located in the holder of the inside handle of the door lock.
After separating the door upholstery from the door, release the electrical connectors and remove the door upholstery from the vehicle.
To access the outside handle of opening the door or the power window, remove the dust and moisture protective film from the door.