Raise the door glass all the way, then remove the upholstery and dust and moisture protective film from the door.
Through the hole in the inner panel of the door, release the plastic clips and disconnect the pull rods of the outer and inner door handles and the lock cylinder from the lock. All rods are attached to the lock with plastic clips, which must be removed with force and removed from the rod, then pull the rod out of the clamp hole.
On doors with electric locks, disconnect the electrical connectors from the lock.
Pic. 14.29. The location of the screws securing the door lock to the door on models up to 2001
Pic. 14.30. The location of the screws securing the door lock to the door on models from 2001
Unscrew the screws securing the lock to the door and remove the lock through the hole in the inner panel of the door (pic. 14.29, 14.30).
On models since 2001, unscrew the screw securing the inner handle, separate the handle from the door and remove the lock together with the inner handle.
Install in the reverse order of removal, taking into account the following:
Fix the dust and moisture protection film by installing it without wrinkles or tears. The surface on which the dust and moisture protective film is glued must be perfectly clean.