Raise the door glass all the way.
Turn off the ignition and disconnect the wire «masses» from the battery.
Open the door and support it with stands or jacks, placing a clean rag between them and the door.
Remove the upholstery and dust and moisture protective film from the door.
Label and disconnect from the door all electrical connectors, wire clamps and wire connecting to «weight».
Disconnect the protective corrugated cover from the door and pull the wires out of the door through the opened hole.
Pic. 14.25. Arrangement of bolts of fastening of the limiter of opening of a door
Turn out bolts of fastening of the limiter of opening of a door (pic. 14.25).
Mark the position of the door hinges with a marker.
Pic. 14.26. Arrangement of bolts of fastening of the bottom hinge of a forward door to a door (upper hinge fastening similar)
Pic. 14.27. Arrangement of bolts of fastening of hinges of a back door to a door
While the assistant supports the door, remove the bolts securing the hinges to the door and remove the door from the vehicle (pic. 14.26, 14.27).
To access the rear door hinge bolts, open the front door.
Install the door in the reverse order of removal, taking into account the following:
Fix the dust and moisture protection film by installing it without wrinkles or tears. The surface on which the dust and moisture protective film is glued must be perfectly clean.