2. Remove the door trim.
3. Label and disconnect all connectors, remove wire harnesses from the door.
4. Open the door fully and support it with a block or stand.
5. Draw the outline of the hinges on the body.
 |  |
6. Unscrew the bolts (left - upper, right - lower) of the hinges on the body (the assistant must hold the door) and remove the door.
7. Installation is carried out in reverse order.
8. Align the loops with their outlines.
9. If the door does not close tightly after assembly, loosen the screws slightly (indicated by arrows) and adjust the position of the latch until the door closes tightly.