Contents: Exterior mirrors ↓ Interior mirror ↓
Exterior mirrors
Removal
1. Carefully pry up the decorative mirror trim on the inside of the door using a screwdriver.
2. On models equipped with power mirrors, remove the door interior trim panel and, if necessary, carefully peel off the plastic film (see paragraph 15).
3. Disconnect the wiring connector from the mirror drive, if equipped.
4. Unscrew the three bolts securing the mirror assembly and remove the mirror from the door (see Figure 20.4).
Figure 20.4. Remove the three mirror mounting bolts (top arrows); if the mirror is electric, disconnect the wiring connector (bottom arrows).
Installation
5. Installation of the outside mirror is carried out in the reverse order of removal.
Interior mirror
Removal
6. Wrap the tip of a small screwdriver with tape. Insert a screwdriver into the groove at the base of the mirror to a depth of 6-7 mm, as shown in the figure 20.6 and, having pressed the spring lock of the leg, remove the mirror.
Figure 20.6 To remove the interior rearview mirror, insert a small screwdriver into the slot at the bottom of the base and press down to release the spring clip on the mirror base.
Installation
7. Insert (if you filmed it) spring clip, then insert the tenon of the mirror foot into the groove and press the foot down until it is properly seated in the base.