Doors, locks and windows of the car Toyota Highlander 1 (XU20)

Hinges and locks — maintenance
Hinges and latches for doors, hood and trunk lid (or the tailgate) should be lubricated every 5,000 km or every three months. This is done by adding a few drops of liquid oil or special lubricant for locks. A thin layer...

Windshield and other fixed glass — replacement
To replace the windshield and other fixed glass of the car, you should use one of the special quick-hardening compounds based on glue or sealant. In addition, this work cannot be done properly without the use of some...

Door trim panels — removal and installation
Warning! The models covered by this manual are equipped with a Supplemental Restraint System (SRS), commonly known as the air bag system. To prevent accidental air bag deployment, which could result in injury, be sure...

Door — removal, installation and adjustment
Note: The door is quite heavy and somewhat cumbersome to remove and install. This procedure should be performed by at least two people. Removal and installation 1. Raise the glass in the appropriate door completely and...

Latch, Lock Cylinder and Door Handles — Removal and Installation
Caution: When working inside doorways, use gloves to avoid injury from sharp metal edges. Door latch 1. Lift the glass, then remove the door trim panel and waterproofing sheet ( see paragraph 15 ). 2. Working through...

Door glass — removal and installation
Caution: When working inside doorways, use gloves to avoid cutting yourself on sharp metal edges. Door glass 1. Remove the door trim panel and plastic waterproofing sheet ( see paragraph 15 ). 2. Lower the glass not all...

Door window lifter — removal and installation
Caution: When working inside doorways, use gloves to avoid cutting yourself on sharp metal edges. 1. Remove the door trim panel and plastic waterproofing sheet ( see paragraph 15 ). 2. Remove the glass ( see paragraph...

Mirrors — removal and installation
Exterior mirrors 1. Remove the door trim panel as described in paragraph 15 . 2. Disconnect the mirror electrical connector, then remove the three mirror mounting bolts and detach the mirror from the vehicle (Fig....

Tailgate — Removal, Installation and Adjustment
Application: The tailgate is quite heavy and somewhat cumbersome to remove and install. This procedure should be performed by at least two people. Removal and installation 1. Disconnect the ground cable from the battery...

Latch, Lock Cylinder and Tailgate Handle — Removal and Installation
Luggage compartment door latch 1. Disconnect the ground cable from the battery ( see paragraph 1 of chapter 5 ). 2. Open the tailgate and remove the tailgate trim panel and waterproofing sheet as described in paragraph...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Doors, windows and locks Toyota Corona T190 (1992-1997)
➥ Doors, locks and windows Toyota Cruiser 100 (1998-2007)
➥ Doors, locks and windows Toyota Camry XV20 (1996-2001)
➥ Doors, locks and windows Toyota RAV 4 XA10 (1994-2000)
➥ Doors, locks and windows Toyota 4Runner N120 (1989-1995)

Link in different formats to this article

TEXTHTMLBB Code