Front seat
Attention! On some models, the front seat belts are equipped with pretensioners, which are pyrotechnic devices designed to retract the seat belts in the event of an impact. On models equipped with pretensioners, do not remove the front seat belt retractors or disconnect the electrical connectors of these devices. If there is a malfunction in the pretensioners, the SRS warning lamp lights up on the instrument panel (airbag systems). If you suspect a problem with your seat belt pretensioners, have your vehicle diagnosed by your dealer's service department. In addition, on these models, the airbag system should be disabled (see chapter 12).
On models with side airbags, disable that airbag system before starting this procedure (see chapter 12).
1. Pry and remove the plastic covers to access the seat sleds and their mounting bolts.
2. Remove the bolts (pic. 27.2, a, b).
Pic. 27.2, a. Pull out the front...
Pic. 27.2, b....and rear bolts
3. Tilt the seat up and forward to access the underside, then disconnect all electrical connectors and remove the seat from the vehicle.
4. Installation is carried out in the reverse order of removal.
Backseat
5. Remove the bolts on the front side of the rear seats (pic. 27.5).
Pic. 27.5. Loosen the bolts on the front side of the rear seats
6. Swing the seat backs down and release the seat slide covers (pic. 27.6).
Pic. 27.6. Release the seat slide covers
7. Turn out other bolts of fastening of a seat (pic. 27.7).
Pic. 27.7. Loosen the bolts at the back of the seats
8. Installation is performed in the reverse order of removal.