Attention! High-pressure H7 filament bulbs may burst during replacement, so these bulbs must be replaced with gloves and goggles.
Attention! Do not touch the glass bulb of the lamp with bare hands. Fat traces on the lamp lead to the darkening of the bulb and the rapid failure of the lamp. Be sure to replace defective lamps with lamps of the same type. Wipe off any grease stains with a clean, lint-free cloth or alcohol.
Replace bulbs as follows:
Open the hood.
On the reverse side of the headlight, disconnect the electrical connector, after releasing the retainer.
Pic. 15.47. Removing the rubber protective cover from the headlight
Pull back the rubber protective boot and remove it from the headlight (pic. 15.47).
Turn the bulb socket counterclockwise and remove it from the headlight.
By pulling, remove the llama from the cartridge.
Insert the bulb socket into the headlight and turn it clockwise.
Install the rubber protective boot and connect the electrical connector.