Front seat adjustment
Figure 15. Front seat position adjusters.
1 - Seat longitudinal position adjustment lever (similarly for the rear seats).
Grasp the middle of the lever and pull the lever up. Once the seat is in a comfortable position, release the lever.
2 - Seat cushion tilt adjustment handle.
Turn the handle in the desired direction.
3 - Seat backrest tilt adjustment lever.
Lean forward and pull the lever up. Then lean back to a comfortable position and release the lever.
Headrests
To extend the headrest, simply pull it up, to lower the headrest, press the button (2).
Figure 16. Rear seat backrest (1) and headrest (2) position adjusters.
Rear seat adjustment
Note: Folding the rear seats allows you to increase the luggage compartment up to the backs of the front seats.
The seat position can be adjusted longitudinally, as for the front seats.
3-door models: if a passenger is sitting in the rear center seat, adjust the cushions of both seats to the same position so that he or she can use the seat belt correctly.
Pull the seatback tilt adjustment strap (1) upward. Once the seatback is tilted to the desired position, release the strap.
5-door models: if a passenger is sitting in the rear center seat, adjust the cushions of both seats to the same position so that he or she can use the seat belt correctly.
Pull the seatback tilt adjustment strap (1) upward. Once the seatback is tilted to the desired position, release the strap.
Folding, unfolding and removing the rear seats
Before folding the rear seat, fold the seat belt and buckles for the rear center seat to prevent them from falling out when the seatback is folded (figure 17).
Figure 17. Seat belts and buckles folded.
Folding the rear seats
Grasp the center of the lever (figure 15, pos. 1) and pull it up. Then move the front seat forward as far as it will go.
Grasp the center of the rear seat lever and pull it up. Then slide the rear seat back as far as it will go and, pulling it slightly forward, latch it into place.
Lower the headrest down as far as it will go. Pull the belt up to release the seat back and fold it forward, locking it into place.
[The article was copied from the portal: ToyotaMan]
By pulling up on the cushion release lever, the seat cushions are released and the entire seat is folded up and forward.
Make sure the front legs are locked in place to ensure the seat is securely in place.
Figure 18. The rear seat back is folded.
Folding the rear seat
To release the seat, place your hand on the top edge of the seatback and pull the belt up. Tilt the entire seat down and insert the rear legs into the locks on the floor. Make sure the rear legs are securely locked by pulling the back of the seat up.
Pull the strap to release the seat back and fold it upward.
Removal the rear seats
The luggage compartment volume can be increased by removing the rear seats completely.
Fold the rear seats as described above.
Release the seat by pulling the lever. Pull the seat up off the supports and remove it from the vehicle.
Installing rear seats
Pull the lever to engage the rear hinge into the lock on the floor.
Press the seat against the locks and secure it.
Pull the strap up, tilt the entire seat down and insert the rear legs into the locks on the floor until they click into place.
Pull the straps to fold the seat backs.
Heated seats
Figure 19. Seat heating buttons.
To turn on the seat heating, press the switches (left for the left front seat and right for the right front seat).
The seat heater switches have the following positions: "HI" - high heating temperature, "LO" - low temperature.
The ignition key must be in the "ON" position.
By gently pressing the switch in the opposite direction, the seat heaters will be turned off.