Charging system Precautionary measures 1. Connect the battery wires to the terminals correctly. 2. When charging the battery, disconnect it from the car wiring. 3. When measuring, do not use a high voltage tester. 4. Do not disconnect...
Generator (with electronic regulator) Generator disassembly 1. Remove the vacuum pump by unscrewing the four bolts. 2. Remove the rear end cap. A) Remove the nut and terminal insulator. b) Remove three nuts and end cap 3. Remove the brush holder and...
Relay-voltage regulator Regulator status monitoring 1. Remove the regulator cover. 2. Check the condition of the contact surfaces (burning and damage). If there are defects, replace the regulator. 3. Check the resistance between the terminals....
Starting aid system with series resistance (2L-T) Checking the starting aid system Check the glow duration of the glow plug indicator lamp. Turn the starter key to the ON position, measure the lamp duration. Checking the timer (type 1) Check timer circuits. Disconnect...
Starter disassembly 1. Remove the exciter and armature. Types 2.0 kW and 2.2 kW A) Remove the nut and disconnect the lead wire from the magnetic switch terminal. Engine 3L b) Remove the two bolts, spring washers, plate washers and o-rings....
Car stator check 1. Check for an open stator winding. Using an ohmmeter, measure the resistance between the wire terminal and the brush wire as shown in the figure. If the resistance tends to infinity, i.e. circuit is open, replace the...
Starter Assembly Reminder: When assembling the starter motor, use a high-melting grease to lubricate the bearings and gears. 1. Grease the armature bearings, then place the armature in the starter housing. 2. Install the brush holder...
Starter relay Location - in the engine compartment, on the right. Checking the starter relay L series engines 1. Check relay circuits. A) Using an ohmmeter, check for continuity between the terminals "E" And "ST". b) Check for...