Front gear
1. Drive switch connector; 2. Vacuum hoses; 3. Front propeller shaft; 4. Breather hose; 5. Rear support; 6, 14. Retaining ring; 7. Left half shaft; 8, 11. Gasket; 9. Drain plug; 10. Left front support; 12. Right front support; 13. Reducer; 15. Right half shaft
Removal and installation
1. Raise the car and remove the wheels.
2. Remove the bottom engine cover.
3. Drain the gearbox oil.
4. Disconnect the cardan shaft.
5. Remove the axles.
6. Disconnect the breather hose, unscrew the 2 bolts of the holder and disconnect the connector and vacuum hoses of the electromagnetic drive of the front drive axle.
7. Place a trolley with a jack under the gearbox.
8. Loosen the rear nut (photo on the left) and nuts of the two front supports (photo on the right). Lower the gearbox.
9. Installation is carried out in the reverse order.