Front Axle Drive Switch — Checking and Replacing [Toyota 4Runner N120]

1. Disconnect the connector.

2. Check the switch contacts for closure when pressing the pusher.

3. If the test results are negative, replace the switch.

(The original can be read on the website toyotaman.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Gribkov Vladimir

Share information:

◀ Previous

4Runner N120: Transmission line

Next ▶

Front Axle Relay — Checking and Replacing
Front Axle Solenoid Block — Checking and Replacing
Front Axle Drive — Checking and Replacing
Electromagnetic drive of the front drive axle (ADD system)
Replacement of covers and disassembly of CV joint

Front gearbox — removal and installation

Similar articles on other Toyota models

➥ Checking and disassembling the front drive shafts.… Toyota Corolla E80 (1983-1990)
➥ Checking, adjusting tension and replacing the drive belt Toyota Camry XV20 (1996-2001)
➥ Replacing the front rear drive shaft seal Toyota Corona T190 (1992-1997)
➥ Replacing the dust cover and retaining ring of the front… Toyota Carina T190 (1992-1996)
➥ Checking, adjusting tension and replacing drive belts Toyota Cruiser 100 (1998-2007)
➥ Checking the transmission fluid level for an automatic… Toyota Highlander 1 (2000-2007, petrol)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet