Front Axle Solenoid Block — Checking and Replacing [Toyota 4Runner N120]

1. Disconnect the connectors from the solenoids.

2. Check the resistance of the solenoid coils.

3. Apply power and ensure that air enters port E and exits port F. When power is removed, no air should pass through port F.

(The original source is located on the website: TOYOTAMAN.ru)

4. Replace the unit if the results of one of the tests are negative, to do this, disconnect the hoses (A), press the latch (B) and unscrew the bolt (C).

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Gribkov Vladimir

Share information:

◀ Previous

4Runner N120: Transmission line

Next ▶

Front Axle Drive — Checking and Replacing
Electromagnetic drive of the front drive axle (ADD system)
Replacement of covers and disassembly of CV joint
Front axle shafts — removal and installation
Rear Axle — Removal and Installation

Front Axle Relay — Checking and Replacing
Front Axle Drive Switch — Checking and Replacing
Front gearbox — removal and installation

Similar articles on other Toyota models