Turn off the ignition and disconnect the ground wire from the battery.
Remove the alternator drive belt.
Figure 15.16. Generator mounting elements on models before 2001: 1 – hinge bolt; 2 – adjusting bolt; 3 – generator connecting wires; 4 – electrical connector; 5 – generator; 6 – generator drive belt
Figure 15.17. Generator mounting elements on models produced since 2001: 1 – generator drive belt; 2 – wire fastening bracket; 3 – generator connecting wires; 4 – generator; 5 – electrical connector; 6 – wire fastening bracket; 7 – wire fastening clamp
Disconnect the wires and electrical connectors from the generator (figure 15.16, 15.17)
See the source on the internet resource ToyotaMAN.ru
On pre-2001 models, remove the adjuster and pivot bolts.
Figure 15.18. Location of generator mounting bolts on models since 2001
On 2001 and later models, remove the alternator mounting bolts (figure 15.18).
Remove the generator from the vehicle.
Install the generator in the reverse order of removal, taking into account the following:
If a new generator is being installed, transfer the pulley from the old generator to it.
Check the voltage produced by the generator.