Clutch slave cylinder — removal and installation [Toyota RAV4 XA10]

Removal the clutch slave cylinder produce as follows:

Turn off the ignition and disconnect the ground wire from the battery.

Unscrew the union nut and disconnect the pipe from the slave cylinder that transmits fluid pressure from the clutch master cylinder. When loosening the connecting nut, use a socket wrench to avoid damaging the edges of the nut. Use a rag to collect the leaked brake fluid.

Unscrew the mounting bolts and remove the clutch slave cylinder.

Installing the clutch slave cylinder produce as follows:

Install the slave cylinder onto the clutch housing, making sure that the push rod fits into the recess of the clutch release fork, and secure it with bolts, tightening them by hand at this stage.

Connect the tube to the clutch slave cylinder and secure it with a union nut. Finally tighten the clutch slave cylinder mounting bolts to a torque of 12 Nm.

[The publication is taken from the website www.ToyotaMan.ru]

Add brake fluid to the brake system reservoir and bleed the air from the clutch hydraulic drive as described in the relevant section.