Working cylinder
Removing
1. Disconnect the battery from the ground.
2. Raise the front of the car.
3. Disconnect the hydraulic drive tube from the cylinder, unscrew the two bolts (indicated by arrows) and remove the cylinder.
Installation
Connect the hydraulic drive tube and install the cylinder. Insert the plunger into the recess on the clutch fork. Secure the cylinder and bleed the air from the hydraulic actuator.
Battery
Removing
1. Disconnect the battery from the ground.
2. Raise the front of the car.
3. Loosen the cruise control actuator bolts, remove the actuator and set it aside.
4. Remove the battery and battery tray.
5. Remove the starter.
6. Disconnect the tubes from the battery, unscrew the bolts (indicated by arrows) and remove the battery.
Installation
Install the battery, hand-tighten the bolts, attach the tube and finally tighten all connections.