On engines 4E-FE, 4A-FE, 7A-FE
Turn the ignition key to the START position and press the throttle pedal. Hold the key and pedal for no more than 15 seconds, then release. Then remove your foot from the pedal and try starting again.
On 2E model engines
Press the throttle pedal and hold it for 15-20 seconds. Then try to start the engine without removing your foot from the pedal. Do not press the pedal, just hold it near the floor.
If the engine does not start after 15 seconds of starter operation, turn off the starter, wait a few minutes, and then try again.
If the 4E-FE, 4A-FE and 7A-FE engines fail to start, repair or adjustment is required.
If the 2E engine fails to start, follow the above procedure and try the following.
1. Remove the spark plugs and dry the electrodes.
2. Turn the ignition key to the START position and press the throttle pedal. Hold the key and pedal for no more than 15 seconds, then release.
3. Tighten the spark plugs.
4. After removing your foot from the pedal, try to start the engine.
5. If the engine does not start, adjustment or repair is required.