1. Take a trip with the front gear engaged for at least 15 minutes, moving in all gears, including reverse.
2. Raise the vehicle and place it on stands. Remove the drain plug (see subsection 2.33) and drain the oil. Screw the plug back in and tighten.
3. Unscrew the filler plug and pour in fresh oil using a syringe or a syringe. The oil level should reach the bottom edge of the hole. Screw the plug back in.
4. Lower the vehicle. Drive the vehicle, check the level and add oil if necessary. Tighten the plug.
Changing the oil in the transfer case [Toyota 4Runner N120]
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
The article material has been checked: Gribkov Vladimir
Share information:
Similar articles on other Toyota models
➥ Changing the oil in the transfer case Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Changing the transfer case oil on all-wheel drive vehicles… Toyota RAV 4 XA10 (1994-2000)
➥ Checking and replacing oil in manual transmission and… Toyota Camry Vista V40 (1994-1998)
➥ Checking and replacing oil in manual transmission and… Toyota Corona T190 (1992-1997)
➥ Checking and replacing oil in manual transmission and… Toyota Carina T190 (1992-1996)
➥ Checking the Transfer Case Transmission Fluid Level (4WD… Toyota Highlander 1 (2000-2007, petrol)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- 4-cylinder engines
- 6-cylinder engines
- Engine overhaul
- Cooling and heating
- Fuel system
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Transfer case
- Clutch
- Transmission line
- Chassis, running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Ignition system
- Power devices
- Electrical circuits