Hoses and connections — checking and replacing [Toyota 4Runner N120]

Connecting the hose to the tube

1. Hose
2. Clamp

Check and replace

1. Replace fuel hoses and tubes if cracks, dents, or worn rubber are detected.

[The original can be found on this resource: TOYOTAMAN]

2. Decompress before replacing tubes and hoses.

3. Connect the hose to the tube according to the diagram above.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Gribkov Vladimir

Share information:

◀ Previous

4Runner N120: Fuel system

Next ▶

Main Fuel Injection System (EFI) relay and fuel pump relay
Checking the fuel pressure regulator
Checking fuel pressure
Checking the fuel pump
Fuel system decompression procedure

Fuel tank — removal and installation
Fuel pump — removal and installation
Fuel level sensor — checking and replacement
Air filter — removal and installation
Throttle Cable — Removal and Installation

Similar articles on other Toyota models

➥ Checking and replacing hoses in the engine compartment Toyota Camry XV20 (1996-2001)
➥ Replacing spark plugs. Checking electrical connections Toyota Corolla E80 (1983-1990)
➥ Checking and replacing hoses in the engine compartment Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Checking and replacing hoses in the engine compartment… Toyota Highlander 1 (2000-2007, petrol)
➥ Checking and replacing hoses in the engine compartment Toyota RAV 4 XA10 (1994-2000)
➥ Checking and replacing fuses Toyota Corona T190 (1992-1997)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet