2. Fill the reservoir with fresh brake fluid (use of waste liquid is prohibited).
3. Raise the car.
4. Remove the cap, put the hose on the cylinder nipple. Lower the other end of the hose into a container filled with brake fluid 5 cm.
5. Have an assistant depress the clutch pedal fully and loosen the bleeder screw 1/2 turn. Tighten the screw at the end of the pedal travel as instructed by the assistant. Have the assistant slowly release the pedal.
6. Repeat the procedure until air bubbles stop coming out of the hose. Constantly monitor the level - the tank must be completely filled with liquid.
7. With the pedal depressed, tighten the nipple, put on the cap and lower the car. Restore the fluid level in the reservoir.