Bleeding the system will be required every time after disassembling and assembling the clutch hydraulic drive.
1. Fill reservoir with fresh DOT-3 brake fluid (the use of waste fluid is prohibited).
2. Raise the front of the car.
3. Put a hose on the cylinder fitting and release it into a container filled with brake fluid by 5 cm.
4. Have an assistant depress the clutch pedal all the way. Turn off the pumping union, having released a liquid, tighten the union and ask the assistant to release a pedal slowly. Repeat the procedure until no more air bubbles come out of the hose.
5. When pumping, constantly monitor the level, preventing fluid from leaving the tank.