Doors, locks and windows of the car Toyota Camry 2 (XV20)

Maintenance of hinges and locks
Every 5,000 km or every three months, apply a few drops of light oil or lock lubricant to the hinges and latches on the doors, bonnet and trunk. The door lock latches should also be coated with a thin layer of grease to...

Windscreen and fixed glass
Replacing the windshield and fixed glass requires the use of a special fast-curing adhesive or sealant and some specialized equipment. It is recommended that these operations be performed at service stations.

Central locking — general information
Central locking is provided on some vehicles. All doors can be locked and unlocked using the key or the button on the driver's door. The switch on the driver's door armrest can be used to lock and unlock all doors...

Trunk lid — removal, installation and adjustment
Attention! Work should be performed by two people. Removal 1. Open the trunk lid and cover the adjacent body panels. 2. Remove the inner trim of the lid and disconnect the connectors of the trunk lighting and rear...

Trunk lid latch and lock — removal and installation
Latch 1. Draw the outline of the lid latch. 2. Unscrew the two mounting bolts and remove the latch. 3. Disconnect the cable from the latch. 4. Installation is carried out in reverse order. Trunk lid lock 1. Loosen the...

Fuel filler door/trunk lid release cable
1. Disconnect the cable and remove the trunk lid latch (see subsection 11.14. ). 2. To access the fuel filler door cable, remove the trunk mat and the left side trim. Turn the cable end counterclockwise 1/4 turn and...

Door trim panels — removal and installation
Removal 1. On vehicles with manual window lift, remove the window lift handle by removing the clip with a cloth. 2. Remove the lock release button. 3. On vehicles with electric windows, pry up and remove the switch...

Door — removal, installation and adjustment
Attention! The work is performed by two people. Removal 1. Lower the window and disconnect the battery from ground. 2. Open the door and place a stand under it. 3. Remove the door trim panel. 4. Mark and disconnect all...

Latch, door lock and handle
Latch 1. Raise the glass and remove the door trim and water shield (see subsection 11.16. ). 2. Through the opening in the door frame, disconnect the rods from the outer handle to the latch, from the lock to the latch,...

Door glass — removal and installation
Front door glass 1. Raise the glass and remove the door trim and water shield (see subsection 11.16. ). 2. Lower the window completely. 3. Lift the glass just enough to provide access to the glass mounting bolts through...

Window lifter — removal and installation
Front door window lifter 1. Remove the door trim and water shield (see subsection 11.16. ). 2. Remove the glass. 3. On vehicles with power windows, disconnect the window motor connector. 4. On Avalon or Solara models,...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Doors, locks and windows Toyota RAV 4 XA20 (2000-2005)
➥ Doors, windows and locks Toyota Corona T190 (1992-1997)
➥ Doors, locks and windows Toyota Highlander 1 (2000-2007, petrol)
➥ Doors, locks and windows Toyota Cruiser 100 (1998-2007)
➥ Doors, locks and windows Toyota 4Runner N120 (1989-1995)

Link in different formats to this article

TEXTHTMLBB Code