Removing
Pic. 9.1. Gearbox control cables on models up to 2001: 1 – gear lever handle; 2 - corrugated protective cover; 3 – central console; 4 - clamp; 5 - clamp; 6 - bracket; 7 – the block of the lever of a gear change; 8 - clamp; 9 - washer; 10 – a cable of a choice of transfers; 11 - washer; 12 - washer; 13 - clamp; 14 - clamp; 15 – a cable of a gear change; 16 - holder; 17 - seal; 18 – seal holder; 19 – side upholstery panel; 20 - side upholstery panel
In the engine compartment, remove the clamps and washers and disconnect the cables from the gear levers (pic. 9.1).
Remove screws, seal retainer and cable seal from engine bulkhead.
Remove the center console from inside the car.
Remove the clips securing the cable sheaths to the shift lever base.
Remove the clips and washers and disconnect the cables from the shift lever assembly.
Remove the screws from inside the vehicle and remove the cable seal holder. Pull the cables into the vehicle interior.
Installation
Install in the reverse order of removal.