Front hub and bearing [Toyota 4Runner N120]

Replacement

1. Remove the steering knuckle.

2. Front hub and bearing of the car "Toyota 4 Runner/ Hilux/ Surf" pressed into the fist, removed and replaced at a car service center.

3. Assembly is carried out in reverse order.

[See the source on the internet resource: www.TOYOTAMAN.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Gribkov Vladimir

Share information:

◀ Previous

4Runner N120: Car suspension

Next ▶

Steering knuckle — removal and installation
Front suspension stabilizer — removal and installation
Front suspension springs and shock absorbers (struts)
Technical data of suspension and steering
Suspension and steering design

Ball joints — inspection and replacement
Upper arm — removal and installation
Lower arm — removal and installation
Rear shock absorbers — removal and installation
Rear Anti-Roll Bar — Removal and Installation