2. Remove the speed sensor (arrow indicates bolt).
3. Remove the brake caliper.
4. Remove the brake disc.
5. Remove the brake shield (on the left - brake shield bolts on rear-wheel drive vehicles, on the right - brake shield bolts on four-wheel drive vehicles).
6. Disconnect the tie rod end from the knuckle.
7. Loosen and loosen the castle nut (do not turn away), then use a puller to press the ball joint pin out of the upper arm.
8. Loosen and loosen the castle nut (do not turn away) bottom support (arrow).
9. Using a puller, press out the lower support pin.
10. Disconnect the knuckle from the suspension arms and remove.
11. Assembly is carried out in the reverse order.