2. Removing the bearing holder.
a) Using a screwdriver, remove the retaining ring.
b) Remove the bearing holder.
3. Remove the dust cover from the center bearing side.
4. Remove the bearing.
a) Remove the shaft retaining ring.
The material is reprinted from an online resource: ToyotaMan.ru
b) Remove the bearing from the shaft side.
c) Remove the retaining ring.
5. Install the bearing.
a) Press the new bearing into the bearing retainer.
b) Using a screwdriver, install a new retaining ring.
c) Press the bearing holder into the outer joint.
6. Install the new retaining ring as shown in the figure.
7. Install the boot.
a) Press in the new boot as shown in the figure.
b) Press in the new boot as shown in the figure.
