Attention! If the vehicle is equipped with electronically controlled air suspension, turn off the suspension height control switch before raising the vehicle.
2. Open the hood.
3. Release the fasteners and remove the locker (pic. 11.3).
4. Disconnect facing of a forward bumper from a wing which is subject to removal (see paragraph 11).
5. Working from the inside, remove the fender-to-body fastener (pic. 12.5).
Pic. 12.5. Remove the wheel arch bolt
6. If you are removing the fender on the passenger side, remove the radio antenna (see chapter 12).
7. Open the front door and remove the upper wing-to-body bolt (pic. 12.7).
Pic. 12.7. Turn out the top bolt of fastening of a wing at an open door
8. Turn out the bottom bolts of fastening of a wing to a body (pic. 12.8).
Pic. 12.8. Remove the bolts located along the bottom edge of the wing
9. Turn out the top bolts of fastening of a wing (pic. 12.9).
Pic. 12.9. Remove the three bolts located along the top edge of the wing
10. Remove the fender. Have an assistant support the fender as it is removed from the vehicle to prevent damage to adjacent body panels.
11. Installation is carried out in the reverse order of removal. By finally tightening the wing fastening bolts, check the position of the wing relative to the hood and the front edge of the door.