Contents: Removal ↓ Installation ↓
Removal
1. Raise the car and remove the wheel.
2. Remove the front turn signal/parking light (see subsection 1.3.5.2.).
3. The protective panel is secured with bolts, screws and plastic clips (arrows).
4. Loosen the screws and remove the clips securing the wheel arch protective panel, remove the panel and mudguard.
5. Open the front door and unscrew the bolt securing the wing to the body.
6. Unscrew the bolt securing the lower wing to the body.
7. Remove the bumper panel bolt (A) at the lower front of the fender, then the fender-to-bracket bolt (B).
8. After removing the turn signal/parking light housing, unscrew the bolt securing the front wing to the bracket (arrow).
9. Remove the three mounting bolts along the top of the wing.
10. Working with an assistant, lift and remove the wing.
Installation
Installation is performed in reverse order. Before tightening the bolts, check that the wing surface matches the door and hood surfaces.
See the source on the internet resource: TOYOTAMAN.ru