Bracket for fastening the nipple
1. Tube; 2. Bracket; 3. Hose
Check and replace
1. Clean the fittings from dirt.
[The original is this website: toyotaman.ru]
2. Unscrew the tube nipple from the hose and remove the clamp. Disconnect the hose from the caliper and remove.
3. Installation is performed in reverse order. When installing the hose, replace the copper gaskets of the ring fitting. Position the hose so that it does not touch the suspension and steering components (do not lift the car during assembly). Remove air from the hydraulic drive.
4. When replacing pipes, make sure that they are secured with clamps along the entire route.
5. Only steel tubes that exactly match the vehicle make are allowed to be installed.