2. The car must be in a horizontal position, the engine must be warmed up.
3. Unscrew the oil filler cap.
4. Substitute the pan, clean and unscrew the drain plug. Drain the oil.
5. Clean and tighten the drain plug.
6. Place a container under the oil filter, lower the car.
7. Using a special key, release the oil filter, then turn it out by hand. Tilt the filter immediately and drain the oil into a container.
8. Thoroughly wipe the filter seat on the engine with a clean rag.
9. Lightly lubricate the O-ring of the new filter with engine oil and screw the filter back into place. Tighten the filter by hand.
10. First, pour half the volume of oil, then wait a few minutes for all the oil to glass into the pan. Continue to add oil in small portions until the mark is reached "H" on the probe.
11. Start the engine and, with the engine running, check the tightness of the sump plug and filter by following these places for several minutes.
12. Stop the engine and wait a few minutes for the oil to drain into the sump. Check the oil level again. After filling all the channels and the filter, the oil level may drop. If necessary, add oil up to the mark "H".