Attention: when operating in severe conditions, replace every 5000 km (or 6 months.).
1. Park the vehicle on a level, level surface.
2. Warm up the engine for several minutes to normal operating temperature, then turn off the engine.
3. Drain the old engine oil.
- A) Remove the oil filler cap. l
- b) Remove the drain plug and drain the oil into a container. l
4. Replace oil filter.
- A) Using the special tool, remove the oil filter. l
- b) Check and clean the oil filter mating surface on the cylinder block. l
- V) Apply some new engine oil to the gasket surface of the new oil filter. l
- G) Screw on the new filter by hand until the gasket is snug against the contact surface. l
- d) Using the special tool, tighten the oil filter 3/4 turn. l
3. Fill in new engine oil.
A) Clean the drain plug, install a new gasket if necessary, and tighten the drain plug.
Tightening torque - 25 Nm
b) Fill in new engine oil.
Filling capacity:
2C:
until 08.1994
without filter replacement - 4.8 l
with filter replacement - 5.3 l
dry engine:
- 4WD - 5.5 L
- 2WD - 5.8 L
since 08.1994
without filter replacement - 3.6
with filter replacement - 4.3
3S-FE, 4S-FE:
- without filter replacement - 3.7 l
- with filter replacement - 3.9 l
- dry engine - 4.5 liters
4A-FE, 5A-FE:
until 08.1994
- without filter replacement - 3.1 l
- with filter replacement - 3.3 l
- dry engine - 3.5 l
since 08.1994
- without filter replacement - 2.8 l
- with filter replacement - 3.0 l
7A-FE:
- without filter replacement - 3.5 l
- with filter replacement - 3.7 l
V) Install the oil filler cap.
4. Start the engine and check for leaks.
5. Check engine oil level.