1. Remove the engine assembly with the gearbox in the block with the drive axle with the transfer case attached to them (see chapter 2B).
2. Remove the engine cross support bracket from the transfer case and engine.
3. Remove the bolts and nuts securing the transfer case.
4. Separate the transfer case from the engine and gearbox assembly.
5. Installation is performed in the reverse order of removal.
Transfer case — removal and installation [Toyota Highlander XU20]
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
The article material has been checked: Kondratyeva Ulyana
Share information:
Similar articles on other Toyota models
➥ Checking and replacing oil in manual transmission and… Toyota Camry Vista V40 (1994-1998)
➥ Checking and replacing oil in manual transmission and… Toyota Corona T190 (1992-1997)
➥ Checking and replacing oil in manual transmission and… Toyota Carina T190 (1992-1996)
➥ Checking the oil level in the transfer case Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Checking the oil level in the transfer case Toyota 4Runner N120 (1989-1995)
➥ Checking the oil level in the transfer case of vehicles… Toyota RAV 4 XA10 (1994-2000)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Introduction to the guide
- Troubleshooting
- Maintenance
- Power unit
- 4-cylinder engine
- 6-cylinder engine
- Overhaul of engines
- Cooling and heating
- Supply and exhaust system
- Engine electrical equipment
- Control system
- Transmission
- Automatic gearbox
- Drive shafts and cardan
- Chassis, running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits