Camshaft position sensor (CMP) (models produced since 1998)
Removal
1. The camshaft position sensor detects the piston position of cylinder No. 1 to synchronize sequential fuel injection signals to each cylinder. This sensor is mounted on the cylinder head near the camshaft sprocket (see figure 10.1, a, b).
Figure 10.1,a. Camshaft position sensor - models produced before 2000.
Figure 10.1,b. Camshaft position sensor - models produced since 2001.
2. Make sure the ignition key is in the OFF position.
3. Remove the air filter housing (see chapter 4A).
4. Disconnect the wiring connector, unscrew the mounting screws and remove the camshaft position sensor from the cylinder head (see Figure 10.4).
Figure 10.4. Location of the camshaft position sensor (shown by the arrow) in models produced since 2001.
Installation
5. Installation of the camshaft position sensor is carried out in the reverse order of its removal.
The official source is on the portal toyotaman.ru