Remove the windshield wiper arm cover.
Remove the front left windshield wiper arm with brush assembly.
Remove the front right windshield wiper arm with brush assembly.
Remove the upper edge seal of the engine compartment bulkhead.
Remove the top right hood vent
Remove the top left hood vent
Remove the windshield wiper motor with rods assy
Remove the outer hood panel.
Removing the camshaft angle sensor
Disconnect the 2 wire harness clamps.
Pic. 2.581. Camshaft Angle Sensor Wiring Attachment
Loosen the bolt and disconnect the wiring harness (pic. 2.581).
Turn away a bolt and disconnect a plait of wires.
Disconnect the camshaft angle sensor connector.
Remove the bolt and remove the camshaft angle sensor.
Install the camshaft angle sensor.
Tightening torque: 8.8 Nm.
Note. Install other components in the reverse order of removal.
Note. Replacing the crank angle sensor (1CD-FTV)
Disconnect the negative battery terminal.
Remove the #1 motor bottom guard.
Remove the lower right engine cover.
Removing the crank angle sensor
Disconnect the crank angle sensor connector.
Pic. 2.582. Removing the crank angle sensor
Turn out a bolt and remove the gauge of an angle of rotation of a cranked shaft (pic. 2.582).
Install the crank angle sensor.
Tightening torque: 8.8 Nm.
Install the lower right engine cover.
Install the #1 engine bottom guard.
Connect the negative terminal to the battery terminal.
Tightening torque: 5.4 Nm.