Holders (caps) — removal and installation If holders are used when fastening parts (caps), when removing and installing them, refer to the corresponding drawings (see symbols in pictures).
Front bumper — removal and installation At removal and installation of a bumper be guided by the corresponding assembly drawing. Front bumper (CORONA, CALOINA): 1 - fender liner, 2 - engine protection cover, 3 - protective cover, 4 - bumper reinforcement, 5 -...
Hood adjustment Note: Adjustment of the hood and its lock cannot be performed when the hood and lock are fastened with centering bolts. When adjusting, these bolts should be replaced with regular bolts with washers. 1. Adjustment of...
Rear bumper — removal and installation At removal and installation of a bumper be guided by the corresponding assembly drawing. rear bumper (CORONA PREMIO): 1 - bumper side brackets, 2 - bumper rails, 3 - lower bumper trim, 4 - upper bumper trim rear bumper...
Windshield wipers and washers Windshield wipers and washer: 1 - wiper arm, 2 - ventilation grille, 3 - seal, 4 - wiper drive assembly, 5 - wiper drive motor, 6 - washer nozzles Removing the windshield wiper 1. Remove the following parts: A)...
Instrument panel — removal and installation Note: when removing and installing the instrument panel, refer to the relevant assembly drawings. Dashboard (CORONA EXIV): 1 - instrument panel amplifier, 2 - latch No. 1, 3 - side window heating deflector, 4 - glove...
Fuel tank and fuel lines Fuel tank and fuel lines (CORONA EXIV) Fuel tank and fuel lines (CORONA, CALDINA) Fuel tank and fuel lines (CORONA PREMIO): 1 - fuel pipe, 2 - fuel pump, 3 - fuel tank, 4 - fuel tank fastening tape, 5 - fuel supply...
Body dimensions (CORONA, CALDINA) Engine compartment Note: Large letters in the table indicate the right side of the car, and small letters - the left. Engine compartment 3D Dimensions Doorways doorways Rear end Rear end (CORONA) Rear end (CALDINA)...