 |  |
 |  |
The material is republished from an online website ToyotaMAN
The material is republished from an online website ToyotaMAN
Holders (pistons) — removal and installation [Toyota Corona T190]
If holders (pistons) are used to fasten parts, use the corresponding drawings when removing and installing them (see legend in the pictures).
The material is republished from an online website ToyotaMAN
The material is republished from an online website ToyotaMAN
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
The article material has been checked: Kondratyeva Ulyana
Share information:
Similar articles on other Toyota models
➥ Holders (pistons) — removal and installation Toyota Camry Vista V40 (1994-1998)
➥ Holders (pistons) — removal and installation Toyota Carina T190 (1992-1996)
➥ Connecting rods and pistons — check Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Pistons and connecting rods — removal Toyota Highlander 1 (2000-2007, petrol)
➥ Checking the condition of connecting rods and pistons Toyota 4Runner N120 (1989-1995)
➥ Pistons and connecting rods — removal Toyota RAV 4 XA20 (2000-2005)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engines 3S-FE/GE and 4S-FE
- Engines 4A-FE and 7A-FE
- Engines 5E-FE
- Diesel engines 2C and 2C-T
- Engine overhaul
- Cooling system
- Lubrication system
- Fuel injection (petrol)
- Control system (petrol)
- Fuel system (diesel)
- Turbo diesel
- Ignition system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts and cardan
- Chassis, running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Body and interior elements
- Doors, windows and locks
- Heating and air conditioning
- Electrical equipment
- Equipment and devices
- Lighting and signaling
- Electrical circuits