Dismantling the front door 1. Remove a decorative overlay of the internal handle of a door. A) Loosen the screw, press on the trim as shown in the figure and detach it. 2. Remove the power window handle by removing the retaining ring with a piece...
Door glass replacement 1. Remove the glass holder with a screwdriver. 2. Moisten the inside of the rubber insert with soapy water. 3. Install the cage by lightly tapping it with a hammer.
Assembly of the front door 1. Install corner glass. A) Attach the seal to the glass. Warning: If the sealing conditions are not met when installing the old seal, install a new seal. b) Moisten contact surfaces with soapy water. V) Using "A" as a...
Rear doors — design description Components of the rear door: 1 - Door glass, 2 - Outer seal, 3, 4 - Clamp, 5 - Internal seal, 6 - External door handle, 7 - Internal handle for closing the door, 8 - Internal handle for opening the door, 9 - Door lock,...
Front door adjustment 1. Adjust the door in the front, rear and vertical directions. A) After removing the two screws, remove the rear view mirror. b) Adjust the door by loosening the door side hinge bolts. V) Install the rearview mirror. 2....
Windshield — removal 1. Remove: leash with wiper brush, interior rearview mirror, sun visor, assist handle. 2. Remove the windshield. A) When reusing the seal: apply adhesive tape to the opening of the body around the seal. b) Loosen the...
Windshield installation 1. Treat the surfaces of the body and glass in contact with the seal with a cleaning compound. 2. Install the seal on the glass. Warning: If the sealing conditions are not met when installing the old seal, install a new...
Rear window — removal 1. Remove the cab rear window seal as shown. 2. Remove back glass and a sealant. A) From inside the machine, press down on the bottom of the glass and remove it by pulling it down. Remove the seal.
Rear window installation 1. Install the seal on the glass. A) Install the seal on the glass and insert the cord into the groove of the seal as shown in the figure. Note: If the sealing conditions are not met when installing the old seal,...
Instrument panel — removal 1. Disconnect the negative battery terminal. 2. Disconnect the throttle cable (diesel engine). A) Remove the cable handle as shown, then the cable nut and cable. 3. Remove the choke cable. A) Loosen the handle fixing...
Disassembly and assembly of the instrument panel Disassembly 1. Remove the central deflector. A) Remove the center deflector handle. b) Remove the center deflector. V) Disconnect the heater control cable. 2. Remove the side deflector. 3. Remove the speaker. 4. Remove...