Lighting and light signaling Toyota Corona 9 (T190)

Headlights and side lights
Component arrangement (models since 1996): 1 - Engine compartment fuse and relay box: HEAD (LH) fuse, HEAD (RH) fuse, DOME fuse, headlight control relay, 2 - headlights, 3 - fog lights, 4 - combination switch: light...

Checking the headlight relay
Models before 1996 1. Check for constant conductivity between terminals "1" and "2". 2. Check for conductivity between terminals "3" and "4" when applying battery voltage between terminals "1" and "2". Models after 1996...

Checking the side light relay
Models before 1996 Models after 1996 1. Check for constant conductivity between terminals "1" and "2". 2. Check for continuity between terminals "3" and "5" when applying battery voltage between terminals "1" and "2"....

Checking the headlight switch relay
State Conclusion Constantly 1 -4, 2-4 Battery voltage between terminals "2" and "4" 2-3-4 If the conductivity is not as specified, replace the relay.

Checking the fog light relay
Models before 1996 Models after 1996 1. Check for conductivity between terminals "1" and "2" of the relay. 2. Connect the battery to terminals "1" and "2" of the relay and check for conductivity between terminals "3"...

Automatic lighting system
1. Check the system operation. a) Turn on the ignition. b) Set the light switch to the "AUTO" position. c) Close the light sensor and check that the instrument lighting and headlights turn on. d) Open the light sensor,...

Checking the headlight range adjustment system (models before 1996)
1. Checking the switch. a) Check the conductivity between the terminals of the switch connector according to the table. Switch position Conclusions "0" 1-6 "1" 2-6 "2" 3-6 "3" 4-6 Backlight 7-9 b) If the conductivity...

Light Not Switched Off Warning System
Models before 1996 1. Check the door limit switches (see the relevant section). 2. Check the operation of the light warning relay. a) Connect the positive wire from the battery to terminals "5" and "7", and the negative...

Footrest lighting system
1. Check the door limit switches (see the relevant section). 2. Check the operation of the light warning relay. a) Connect the battery to terminals "5" (+) and "1" (-) of the relay. b) Connect a 3.4W test lamp between...

Fog lights
Checking the front fog light switch 1. Check for continuity between terminals "2" and "3" in both switch positions. 2. Check for continuity between terminals "7" and "8" in the "OFF" position. 3. Check for conductivity...

Direction indicators and hazard warning lights
Checking the turn signal switch Cm. Checking the combination switch . Checking the hazard warning switch If the conductivity does not match the table, replace the switch. Checking the turn signal relay 1. Connect the...

Interior Lighting — Check
Checking the glove box light switch 1. Check for conductivity between terminals "1" and "2" when the button is pressed and for conductivity when the button is released. If the conductivity does not match the...

Reversing lights — check
Checking the Reverse Light Switch 1. Check for conductivity between terminals "1" and "2" of the connector while the button is pressed. 2. Check for conductivity between the connector terminals when the button is...

Checking the brake light switch
1. Check for conductivity between terminals "1" and "2" when the button is released (the brake pedal is pressed). 2. Check for conductivity between terminals "1" and "2" when the switch button is pressed (the brake...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Headlights and lighting Toyota Carina T190 (1992-1996)
➥ Lighting system Toyota Corolla E80 (1983-1990)
➥ Headlights and lighting Toyota Camry XV10 (1991-1996)

Link in different formats to this article

TEXTHTMLBB Code

Corona T190 (1992-1997)