Car manual gearbox Toyota Corona 9 (T190)

Removal the gearbox C50 and C52
Removal and installation of gearbox C50 and C52: 1 - air filter, 2 - clutch hydraulic tube bracket, 3 - holder, 4 - cotter pin, 5 - washer, 6 - control cable, 7 - left engine mount bracket, 8 - left engine mount, 9 -...

Installation of gearbox C50 and C52
1. Align the splines of the primary shaft and the driven clutch disc, and install the gearbox on the engine. Tightening torque: Bolt M12 64 Nm Bolt M10 46 Nm 2. Install the rear engine mount bracket and secure it with...

Removal the C58 gearbox
Removal and installation of gearbox C58: 1 - engine protection cover (left side), 2 - engine protection cover (right side), 3 - spring, 4 - oxygen sensor connector, 5 - gasket, 6 - bracket, 7 - front engine mount with...

Gearbox C50, C52 and C58 — design description
Gearbox C50; C52 and C58: 1 - release bearing; 2 - clutch release fork; 3 - case; 4 - speed sensor (C50; C52); 5 - gear shift lever housing support bracket; 6 - clutch housing; 7 - oil receiver; 8 - adjusting washer; 9...

Removal the S50, S54 and S55 gearbox
Removal and installation of gearbox S50, S54 and S55: I - air filter, 2, 4 - holder, 3 - clutch hydraulic tube bracket, 5 - cotter pin, B - washer, 7 - control cable, 8 - left engine mount, 9 - gearbox housing...

Installation of gearbox S50, S54 and S55
1. Align the splines of the primary shaft and the driven clutch disc and install the gearbox on the engine. Tightening torque: Bolt M12 64 Nm Bolt M10 46 Nm 2. Install the rear engine mount bracket and secure it with...

Gearbox S50, S54 and S55 — design description
Gearbox S50 and S55. (Sedan): 1 - primary shaft bearing holder; 2 - clutch release fork; 3 - driven gear of the speedometer; 4 - reverse gear engagement limiter; 5 - Reversing light switch; 6 - blocking device No.1; 7 -...

Transmission of 4WD models
Differential 2WD models: I - driven gear of the main transmission, 2 - oil seal, 3 - adjusting washer, 4 - outer ring of the bearing, 5 - bearing, 6 - thrust washer, 7 - satellite, 8 - satellite axis, 9 - half-axle...

Checking the mechanical locking system of the interaxle differential
1. Checking the operation of the mechanical locking system of the center differential. a) Using a jack, raise the vehicle so that all four wheels can rotate, b) Apply the parking brake and start the engine. c) Engage...

Checking the center differential lock indicator switch sensor
1. Check the conductivity of the sensor-switch according to the table. Switch position Conclusions Conductivity not pressed 1-2 no pressed 1-2 there is 2. If the conductivity does not correspond to the table, replace...

Checking the electromagnetic valves
1. Disconnect the connectors of valves No.1 and No.2. 2. Check valve #1. i) Apply voltage from the battery to the terminals of valve No.1 and make sure that air passes between the filter and the hose "E1". b) Disconnect...

Checking the vacuum drive
1. Check the vacuum drive of the center differential lock system. a) Disconnect hoses No.0, No.2 and No.3 from the solenoid valves. b) Insert the plug into hose No.3. c) Create a vacuum of 500 mmHg in the NsO hose and...

Transfer case — design description
Note: For the procedure for changing the oil in the transfer case, see the chapter " Maintenance ". Transfer case: 1 - transfer case oil pipe, 2 - adjusting gasket, 3 - O-ring seal, 4 - oil seal, 5 - dust cover, 6 -...

Gear shift lever and control cables
Shift Lever and Control Cables (Type 1): 1 - engine protection cover (left side), 2 - engine protection cover (right side), 3 - spring, 4 - oxygen sensor connector, 5 - gasket, 6 - exhaust pipe, 7 - rivet, 8 - heat...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Car gearbox Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Manual gearbox Toyota Corolla E80 (1983-1990)
➥ Manual gearbox Toyota RAV 4 XA20 (2000-2005)
➥ Mechanical gearbox Toyota 4Runner N120 (1989-1995)
➥ Manual gearbox Toyota Dyna Y50/Y60 (1984-1995)
➥ Mechanical gearbox Toyota Camry XV10 (1991-1996)

Link in different formats to this article

TEXTHTMLBB Code

Corona T190 (1992-1997)