Note. The MAF/IAT sensor is located on top of the air filter housing.
1. Disconnect the ground wire from the battery (see paragraph 1 of chapter 5).
2. Disconnect the MAF sensor electrical connector (pic. 8.2).
Pic. 8.2. To disconnect the MAF sensor electrical connector, press the locking tab (1) and disconnect the electrical connector, then remove the screws securing the sensor (2) and remove the sensor from the air filter housing (V6 model shown, same for 4-cylinder models)
3. Turn out screws and remove the gauge.
4. Remove the sensor O-ring and discard.
5. Installation is carried out in the reverse order of removal. Use a new o-ring.