Examination
1. Raise the vehicle.
2. Disconnect the connector from the switch.
3. With the ignition off, check the resistance between the switch terminals (see table. Resistance between switch terminals). Adjust switch or replace if necessary.
Adjustment
1. Move the selector to position N.
2. Loosen switch bolt (2) and adjust the position, to do this, release the bolt, insert the groove (3) along the neutral line (1) and while holding the switch, tighten the bolt.
3. To replace the switch, unlock the washer and unscrew the nut.
4. Loosen the bolt and remove the switch.
5. Assembly is carried out in the reverse order. Adjust switch.
Resistance between switch terminals
Selector position | Normally closed terminals | Normally closed terminals |
P | 4 – 7 | 5 – 6 |
R | 4 – 8 | – |
N | 4 – 10 | 5 – 9 |
D | 4 – 9 | – |
2 | 2 – 4 | – |
L | 2 – 3 | – |