Camry Corolla Corona Carina Land Cruiser Highlander 4Runner RAV4 Others

Corona T190 (1992-1997)

Checking the lower ball joint [Toyota Corona T190]

0

Check the ball joint rotation moment.

a) Before installing the nut, rock the ball joint axle from side to side 5 times.
b) Using a torque wrench, rotate the nut continuously (one revolution in 2-4 seconds) and take a reading on the fifth revolution. The scrolling moment is 1.0 -2.9 Nm.

(The official source is on the portal: «www.ToyotaMAN.ru»)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kondratyeva Ulyana

Share information:

◀ Previous

Corona T190: Front suspension

Next ▶

Removal the lower ball joint
Lower ball joint — design description
Installing the lower control arm
Removal the lower arm
Lower control arm of the front suspension — description of the design

Installing the lower ball joint
Anti-roll bar — design description
Removal the anti-roll bar
Checking the anti-roll bar
Installing the anti-roll bar

Similar articles on other Toyota models

➥ Removal, checking and installation the lower ball joint Toyota Camry XV30 (2001-2006)
➥ Checking the lower ball joint Toyota Carina T190 (1992-1996)
➥ Checking, removing and installing the ball joint Toyota Corolla E80 (1983-1990)
➥ Checking the condition and replacing ball joints Toyota Cruiser 100 (1998-2007)
➥ Checking the condition of the CV joint boots and drive… Toyota RAV 4 XA20 (2000-2005)
➥ Checking the level of operating fluids (every 400 km or… Toyota Highlander 1 (2000-2007, petrol)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Corona T190 (1992-1997)

We require cookies to enable some interactive features. Is that ok with you?