Camry Corolla Corona Carina Land Cruiser Highlander 4Runner RAV4 Others

Corona T190 (1992-1997)

Interior temperature sensor [Toyota Corona T190]

0

Contents: Removal ↓ Examination ↓

Removal

1. Remove the lower trim panel mounting bolts.

2. Disconnect the connector.

3. Release the sensor latch and remove it.

Examination

Measure the resistance between the connector terminals. The resistance should be within 1625-1785 Ohms at 25°C.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kondratyeva Ulyana

Share information:

◀ Previous

Corona T190: Heating and air conditioning

Next ▶

Ambient air temperature sensor
Heater Fan Resistor
Air flow direction flap servo drive
Air flow mixing flap servo drive
Air intake flap servo drive

Sunlight sensor
Evaporator temperature sensor
Compressor Operation Sensor (3S-FE Models Only)
Pressure switch
Heater and Fan Relay

Similar articles on other Toyota models

➥ Interior temperature sensor Toyota Carina T190 (1992-1996)
➥ Coolant temperature sensor Toyota Camry XV20 (1996-2001)
➥ Replacing the intake air temperature sensor (1CD-FTV) Toyota Corolla Verso 3 (2004-2009)
➥ Liquid Temperature Sensor — Checking and Replacing Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Engine Coolant Temperature (ECT) Sensor — Replacement Toyota Highlander 1 (2000-2007, petrol)
➥ Coolant Temperature Sensor — Checking and Replacing Toyota 4Runner N120 (1989-1995)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Corona T190 (1992-1997)

We require cookies to enable some interactive features. Is that ok with you?