Evaporator temperature sensor [Toyota Corona T190]

Examination

By car

Measure the resistance between the connector terminals. Nominal resistance is 1500 ohms at 25°C.

Removed sensor

Place the sensor in cold water with ice. Measure the resistance between the terminals and the temperature. Check that the values are in the shaded area of the table.

[The original version is published on the website: Toyotaman.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kondratyeva Ulyana

Share information:

◀ Previous

Corona T190: Heating and air conditioning

Next ▶

Sunlight sensor
Interior temperature sensor
Ambient air temperature sensor
Heater Fan Resistor
Air flow direction flap servo drive

Compressor Operation Sensor (3S-FE Models Only)
Pressure switch
Heater and Fan Relay
Air conditioning control unit

Similar articles on other Toyota models

➥ Temperature sensor behind the evaporator Toyota Carina T190 (1992-1996)
➥ Coolant temperature sensor Toyota Camry XV20 (1996-2001)
➥ Checking the fan switch temperature sensor Toyota Corolla E80 (1983-1990)
➥ Liquid Temperature Sensor — Checking and Replacing Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Engine Coolant Temperature (ECT) Sensor — Replacement Toyota Highlander 1 (2000-2007, petrol)
➥ Coolant Temperature Sensor — Checking and Replacing Toyota 4Runner N120 (1989-1995)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Corona T190 (1992-1997)